Airsoftjunkiez Trigger Control wire harness for M249 PolarStar FCU V3.0

Airsoftjunkiez Trigger Control wire harness for M249 PolarStar FCU V3.0 Plugs into MCU port of Polarstar FCU REV 3.0  Bare wire to solder to motor terminals inside Box mag    

Bingo/Airsoftjunkiez MP7 Selector wires

Bingo/Airsoftjunkiez MP7 Selector wires   Replacement parts for Bingo/Airsoftjunkiez MP7 HPA kit

Airsoftjunkiez FCU wire harness for LED MAXX Hopup & PolarStar FCU

Airsoftjunkiez FCU wire harness for LED MAXX Hopup & PolarStar FCU Wire harness & Plug only Plugs into MCU port of Polarstar FCU REV 3.0  compatible with LED Maxx hopups    **** does not include FCU nor LED unit

Wolverine Airsoft - MAC Solenoid Valve for Inferno, & Hydra Systems

Wolverine Airsoft - MAC Solenoid Valve for Inferno, & Hydra Systems

Airsoftjunkiez MP7 IGL

Airsoftjunkiez MP7 IGL  

Bingo/Airsoftjunkiez MP7 Trigger wires

Bingo/Airsoftjunkiez MP7 Trigger wires   Replacement parts for Bingo/Airsoftjunkiez MP7 HPA kit

PolarStar - JACK / F2 Bullet Valve Solenoid (BV309A / 200 PSI)

PolarStar - JACK / F2 Bullet Valve Solenoid (BV309A / 200 PSI)

Polarstar Airsoft Universal V3 Trigger Board - (Jack, F1, F2)

Polarstar Airsoft Universal V3 Trigger Board - (Jack, F1, F2) This trigger board is compatible with your PolarStar JACK, F1, and F2 systems! For single solenoid systems such as the Jack or F1, place your solenoid connector into the poppet port. ...

Polarstar V2 Universal Trigger Board (F2, Jack, F1)

Polarstar V2 Universal Trigger Board (F2,Jack,F1) This trigger board is compatible with your PolarStar JACK, F1, and F2 systems! For single solenoid systems such as the Jack or F1, place your solenoid connector into the poppet port.  The F2 will...

ASG FCU LiPo 7.4v 250mAh 20C Battery

Perfect LIPO Battery pack to power HPA Firing Control Unit (FCU) 2 cell 7.4V 250mAh 20C Li-Polymer battery pack. Pre-installed JST PH 3-Pin, JST XH 3-Pin, and red JST 2-pin connectors. Maximum charge rate 12 Amps for burst. Dimensions: 33mm x 20mm...

Polarstar Airsoft Black Poppet for Fusion Engine

Black Original Poppet for Polarstar Fusion Engine. Replacement or upgrade part for your FE. Pair with Redline poppet shim kit for all the customization!

PolarStar - Fusion Engine - O-Ring Set

PolarStar - Fusion Engine - O-Ring Set This set contains all the O-Rings that are needed to replace worn O-Rings on your Fusion Engine/PR-15.This kit contains the following O-Rings:1x Nozzle Outer1x Nozzle Inner4x Manifold1x Poppet Base1x Poppet...